Cautions:
1. Be sure to observe allowable tolerances of eccentricity, deflection and axis.
2. Bolts must be tightened with specified torque.
3. The concentricity of the left and right inner diameter of the coupling is achieved by using speciafequipment, in case thatthe coupling is under strong impact, it may not be able to maintain high accuracy and be damaged in use, please payattention to it during operation.
4. The use range is - 30'c--120'c.Despite water and oll resistance, extreme adhesion can also lead to deterioration of the
product,avoid this kind of situation.
5. Do not tighten the clamping bolt before inserting the installation shaft.
Installations:
1.Confirm whether the bolts on the coupling are loose, and remove the rust, dust and oil on theshaft and the inner diameterof the coupling. in particular, all kinds of greases that have a significant impact on the friction coefficient of the coupling
must not have adhesion.
2. Please insert the coupling into the motor shaft, Wheh inserting, do not apply excessive compression and tension force onthe elastic components of the coupling, especially when inserting the coupling intothe driven shaft after installing thecoupling to the motor, excessive compression force may be exerted due to incorrect operation, please note.
3. When the fixing bolt is loose, please confirm whether the coupling can move slightly along the axial directionand rotation direction, lf it can not move smoothly, please readiust the centering of the two shafts. This methodis recommended as a simple confirmation method of left and right concentricity. lf the same confirmationmethod cannot be used, please use other measurement methods to confirm the installation accuracy.
<li id="cucog"></li>